H3530

Humidity, Temperature, pressure regulator, Ethernet interface

Features
  • Outputs: 2xRelay
  • Space, duct, bar and cable types
  • Dual line LCD
  • Long term stability of parameters
  • Easy programming, adjustment, calibration
Description

Transmitter is equipped with three binary inputs for detection of two-state events - e.g. water, smoke, glass break detection, door contact. Transmitter is equipped with internal terminals for powering of connected external detectors.

Measured temperature and relative humidity is recalculated to other humidity interpretations - dew point temperature, absolute humidity, specific humidity, mixing ratio or specific enthalpy.Reading and pressure output available in these units: hPa, kPa, mbar, mmHg, inHg, inH2O, PSI, oz/in2. Degrees Celsius and Fahrenheit are user selectable.

State-of-the-art capacitive polymer sensor ensures excellent calibration long term stability.Transmitter is equipped with two relay outputs for alarm indication or control of external devices. Each relay can be assigned to any measured or computed value. For each relay setting of delay, hysteresis, audible alarm is enabled.


Technical data
Maximum switching voltage, current of relay output 50V, 2A, 60VA, resistive load
Audible alarm From built-in beeper - switchable
Range of relative humidity measurement 0 to 100%
Operating temperature range of the LCD Readable to operating temperature 70°C
Operating temperature range of case with electronics -30...+80°C
Range of temperature compensation of RH sensor -30...+105°C
Filtering ability of sensor cover 0.025mm (air filter from stainless steel mesh)
Power 9 to 30Vdc
Protection Case with electronics IP30, protection of T+H probe IP40